4 Tricks for Keeping Your Septic System Safe
Around The House,  Home Improvement

4 Tricks for Keeping Your Septic System Safe

4 Tricks for Keeping Your Septic System Safe

Although you may have to deal with septic system backups that involve waste when proper maintenance procedures aren’t implemented, a typical septic system can have other problems as well. Because water conservation impacts how a septic system operates, you must try to use less water throughout the day and night in order to protect to soil around your septic hardware. When a lot of water is used on a regular basis, a septic system suffers since a high volume of water increases soil saturation levels.

Besides your property, other areas will also experience problems when water isn’t properly preserved. If your home is built by a river or lake, you may pollute these water sources with waste each time you overly saturate the soil around your septic system by using too much water. The big benefit is that there are ways to protect a residential landscape, and you can develop a routine for your property by following a few easy steps.

Speed Up Shower Sessions

When a lot of water is used during showering sessions, some of the soapy liquid that goes down the drain might seep around a septic tank. If you understand how many gallons of water generates throughout a showering routine, you can make smarter choices. On average, during a short, four-minute shower, a faucet uses up to 40 gallons of water. In order to use less gallons, simply turn off the water during a shower while building up a lather. Then, let water flow out of the shower faucet when you’re ready to rinse the soap down the drain.

Insulate All Pipes

Insulated pipes can prevent soil problems around a septic tank. If you don’t have insulated pipes, you can upgrade old lines by putting insulated sleeves over the housing. Many hardware stores sell pre-slit foam insulation for pipes, and the process of using these pieces on different kinds of pipes is easy. You can also use solids handling equipment to help with any needs for this project. After all pipes are insulated, your plumbing system won’t waste water as the liquid heats up.

Clean Driveways and Paths with a Broom

In order to clean a large driveway with a hose, you’ll have to spray a high volume of water on the pavement. Since water only blasts out of a hose in an isolated area, you must use several gallons of water to thoroughly remove all dirt and debris on an entire driveway. Although using a broom can be very time-consuming, this cleaning method can help you preserve water and protect your septic system.

Perform Inspections Around Pipes and Faucets

A minor leak can dramatically impact septic hardware by weakening the soil that supports the foundation. During a simple leak, a faucet or fixture will waste nearly 20 gallons of water every 24 hours. When a property has a major leak, a septic system will have higher risks since a large leak wastes over a hundred gallons of water per day. A strong defensive is the best solution, and you can protect your septic system in a practical, defensive manner by inspecting your pipes and faucets for leaks regularly. If you want to ensure dependable results, simply use plumbing services to maintain the float switch that’s included with your septic system. By replacing a defective float switch you’ll prevent overflow problems that can cause:

  • Soggy soil
  • Air pollution
  • Waste backups
Please follow and like us:

Leave a Reply

Your email address will not be published. Required fields are marked *